Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1682 (Engine Controls - Acceleration Control System) >> Removal & Installation >> Accelerator Pedal and Bracket >> Removal

Accelerator Pedal and Bracket: Removal

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connectors.
  1. Disconnect the accelerator pedal sensor electrical connector.
  2. Disconnect the accelerator pedal motor electrical connector.
  3. Disconnect the accelerator pedal motor drive cable connector.
  4. Remove the 3 nuts and the accelerator pedal and bracket assembly.
scientia non olet · About Mike's Workshop Manuals