Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Fuel Charging System & Fuel Control System - 5.4L (4V)) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The fuel pump driver modules (FPDM) are located in the spare tire stowage compartment and are serviced separately.
  1. Disconnect the FPDM electrical connector.
  2. Remove the 2 bolts and the FPDM.
    • To install, tighten to 4 Nm (35 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals