Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1202 (HVAC Control System) >> Removal And Installation >> Blower Motor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the RH scuff plate trim panel from the RH cowl side trim panel.
  2. Remove the RH cowl side trim panel.
  3. Remove the 2 RH lower instrument panel insulator pin-type retainers and the RH lower instrument panel insulator.
  4. Disconnect the blower motor electrical connector.
  5. Release the 2 blower motor vent tube clips and detach the blower motor vent tube from the heater core and evaporator core housing.
  6. Rotate the blower motor counterclockwise to disengage it from the housing and remove the blower motor.
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals