Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1189 (Interior Lighting System) >> Diagnostic Tests >> Interior Lighting >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Electrical
    • Smart junction box (SJB) fuse(s):
      • 9 (15A)
      • 10 (15A)
      • 25 (10A)
    • Wiring, terminals or connectors
    • Courtesy lamps
    • Map lamps
    • Puddle lamps
    • Luggage compartment lamp
    • Vanity lamps
    • Overhead console
    • Instrument panel dimmer switch (part of the headlamp switch)
    • SJB
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool release software.
  4. If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
    5. NOTE: The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • Check the VCM connection to the vehicle.
    • Check the scan tool connection to the VCM.
    • Refer to MODULE COMMUNICATIONS NETWORK article, No Power To The Scan Tool, to diagnose no communication with the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • Verify the ignition key is in the ON position.
    • Verify the scan tool operation with a known good vehicle.
    • Refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication with the SJB or liftgate/trunk module (LTM) (if equipped), refer to MODULE COMMUNICATIONS NETWORK article.
    • If the network test passes, retrieve and record the continuous memory DTCs.
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the SJB and the LTM (if equipped).
  9. If the DTCs retrieved are related to the concern, refer to DTC Tables. For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES article.
  10. If no DTCs related to the concern are retrieved, go to Symptom Chart .
scientia non olet · About Mike's Workshop Manuals