Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Milan Base, 3.0 1, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Information System And Entertainment Systems) >> Removal And Installation >> Satellite Digital Audio Receiver System (SDARS) Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Module configuration is only required if a new Satellite Digital Audio Receiver System (SDARS) module is being installed.
  1. Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
  2. Remove the rear seat backrest. For additional information, refer to SEATING article.
  3. Disconnect the satellite radio antenna cable and the SDARS module electrical connectors.
  4. Remove the 3 nuts and the SDARS module.
    • To install, tighten to 5 Nm (44 lb-in).
  5. To install, reverse the removal procedure.
    • Download the configuration information to the SDARS module. For additional information, refer to PMI in MODULE CONFIGURATION article.
scientia non olet · About Mike's Workshop Manuals