Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2008 >> Sable Base, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems >> Removal And Installation >> Keyless Entry Keypad >> Removal And Installation

Removal And Installation

  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Position the watershield aside.
  3. Disconnect the keyless entry keypad electrical connector.
  4. Release the keyless entry keypad harness from the door panel
  5. Position the front door glass top run aside.
  6. Remove the keyless entry keypad.
    • Through the access hole in the front door pillar, release the keyless entry keypad retainer.
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals