Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2007 >> Montego Premier, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal And Installation

Removal And Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
  3. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals