Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2007 >> Montego Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Continuously Variable Transmission (CVT) >> In-Vehicle Servicing >> Transaxle Support Insulator >> Installation

Transaxle Support Insulator: Installation

  1. Clean the rear transaxle mount bolts using a wire brush and apply new Threadlocker to the threads.
  2. Position the transaxle mount in place and install the upper bolts.
    • Tighten to 55 Nm (41 lb-ft).
    3. Fig 1: Locating Transaxle Mount Bolts
    G03990282Courtesy of FORD MOTOR CO.
  3. Install the rear transaxle mount. Install the bolts.
    • Tighten to 90 Nm (66 lb-ft).
    4. Fig 2: Identifying Bolts For Rear Transaxle Mount
    G03990748Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals