Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2007 >> Montego Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 6 Speed) >> In-Vehicle Servicing >> Transaxle Support Insulator >> Installation

Transaxle Support Insulator: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the rear transaxle mount bolts using a wire brush and apply new threadlock and sealer to the threads.
  2. Position the transaxle mount in place and install the bolts.
    • Tighten to 55 Nm (41 lb-ft).
    3. Fig 1: Identifying Upper Transaxle Mount Retaining Bolts
    G03991478Courtesy of FORD MOTOR CO.
  3. Install the rear transaxle mount.
    • Tighten to 90 Nm (66 lb-ft).
    4. Fig 2: Identifying Bolts For Rear Transaxle Mount
    G03990748Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals