Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2006 >> Montego Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 N.m (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals