Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2005 >> Sable Platinum Edition >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
    Fig 1: Disconnecting Mass Air Flow Sensor Electrical Connector
    G03956586Courtesy of FORD MOTOR CO.
  3. Remove the two retaining screws and the MAF sensor.
    Fig 2: Removing Retaining Screws And MAF Sensor - With Torque Specification
    G03956587Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals