Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2005 >> Montego Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
  3. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals