Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2005 >> Montego Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Position the knock sensor (KS) heat shield aside.
    Fig 1: Locating Knock Sensor
    G03990667Courtesy of FORD MOTOR CO.
  4. Disconnect the KS electrical connector.
  5. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals