Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2005 >> Montego Base, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 2 scrivets and position aside the fender splash shield.
  4. Remove the wheel speed sensor harness pin-type retainer.
  5. Remove the 2 wheel speed sensor harness retainers.
  6. Remove the bolt and the wheel speed sensor.
    • To install, tighten to 8 Nm (71 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals