Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2005 >> Montego Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Accessories Control Systems >> Remote Convenience System >> General Procedures >> Universal Transmitter Programming >> Training a Garage Door Opener Equipped With Rolling Codes

Training a Garage Door Opener Equipped With Rolling Codes

  1. Program the hand-held transmitter to the universal transmitter. For additional information, refer to UNIVERSAL TRANSMITTER PROGRAMMING .
  2. Train the garage door opener receiver to recognize the universal transmitter.
    1. Remove the cover panel from the garage door opener receiver.
    2. Locate the training button on the garage door opener receiver. Location and color of the button may vary by manufacturer. Refer to the GARAGE DOOR OPENER  instruction manual or Owner's Literature.
    3. Press the training button on the garage door opener receiver for 1-2 seconds.
    4. Press the programmed universal transmitter button for as long as the universal transmitter red light flashes (1-2 seconds). Release the button and re-press the button to confirm that the universal transmitter is trained to the receiver.
    5. The garage door opener should recognize the universal transmitter.
scientia non olet · About Mike's Workshop Manuals