Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2002 >> Villager Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1848 (Exterior Lighting System) >> Removal And Installation >> Rear Lamp Assembly >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pin-type retainer and position the luggage compartment trim panel aside.
  2. Remove the 3 nuts and the rear lamp assembly.
    • Disconnect the electrical connectors.
    • To install, tighten the nuts to 6 Nm (53 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals