Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2002 >> Mountaineer 4.6 W, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls - Acceleration Control) >> Removal And Installation >> Pedal - Accelerator and Sensor Assembly, Diesel Engine >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The accelerator pedal and sensor assembly is a non-adjustable, calibrated unit and must be handled with care.
  1. Disconnect the electrical connectors from the idle validation switch and the accelerator pedal position sensor.
  2. Remove the bolts and the accelerator pedal and sensor assembly.
    Fig 1: Removing Bolts Of Accelerator Pedal And Sensor Assembly
    G01540347Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
    Fig 2: Bolts With Torque Specification
    G01540348Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals