Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 1995 >> Villager LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis >> Pinpoint Test E2 >> Check Wires Between ABS Control Module & Wheel Speed Sensors

Check Wires Between ABS Control Module & Wheel Speed Sensors

  1. With ignition switch in OFF position, disconnect wheel speed sensor connectors. Connect breakout box with adapter to ABS control module connector. Leave ABS control module disconnected.
  2. Measure resistance between breakout box pins and wheel speed sensor connector wires specified in PINPOINT TEST E2 TEST TERMINALS table. If resistances are less than 5 ohms, proceed to PINPOINT TEST E3  . If resistances are more than 5 ohms, service suspect wires.
PINPOINT TEST E2 TEST TERMINALS

Breakout Box Pin No. Speed Sensor Connector Wire
Right Side Front 
No. 16 White
No. 56 Green
Left Side Front 
No. 9 Or 43 Yellow/Blue
No. 4 Yellow/Green
Right Side Rear 
No. 25 Blue/Green
No. 49 Orange
Left Side Rear 
No. 45 White/Blue
No. 44 Pink/Blue
scientia non olet · About Mike's Workshop Manuals