Pinpoint Test F - Right Power Rear Quarter Glass Inoperative

With ignition off, disconnect inoperative rear quarter glass motor connector. Using a jumper wire, connect one terminal on rear quarter glass motor to battery positive terminal. See Figure .
Using a jumper wire, connect other terminal on rear quarter glass motor to battery negative terminal. Reverse jumpers on rear quarter glass motor. Rear quarter glass will open or close when battery voltage is applied. When battery voltage is reversed, rear quarter glass will operate in opposite direction. If rear quarter glass motor does not operate as specified, replace rear quarter glass motor. If okay, go to next step.

With ignition off, disconnect rear quarter glass window switch. Measure resistance between terminals on rear quarter glass window switch connector. See RIGHT REAR QUARTER GLASS WINDOW SWITCH RESISTANCES table. If resistances are okay, go to next step. If NOT, replace right power rear quarter glass window switch.

RIGHT REAR QUARTER GLASS WINDOW SWITCH RESISTANCES

Right Vent	Terminal	Ohms
Open	2-3	Less Than 5
"	1-3	Greater Than 10,000
"	2-4	Greater Than 10,000
"	1-4	Less Than 5
Normal	2-3	Greater Than 10,000
"	1-3	Greater Than 10,000
"	2-4	Less Than 5
"	1-4	Less Than 5
Close	2-3	Greater Than 10,000
"	1-3	Less Than 5
"	2-4	Less Than 5
"	1-4	Greater Than 10,000

With ignition off, disconnect left rear quarter glass window switch connector. With ignition on, measure battery voltage of Orange/Black wire at right rear quarter glass window switch connector. If battery voltage is greater than 10 volts, go to next step. If NOT. repair Orange/Black wire.
With ignition off, disconnect right rear quarter glass window switch connector. Measure resistance of Black wire between right rear quarter glass window switch connector and ground. If resistance is less than 5 ohms, repair wire(s) between right rear quarter glass window switch and right rear quarter glass motor. If NOT, repair Black wire.