Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2021 >> Sprinter 2500 Van Cargo Extended, 2.1L Eng >> Repair and Diagnosis >> External Pages >> Different car >> Section 3190 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Removal And Installation >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the trim from the left rear quarter panel to access Fuel Pump Control Module (FPCM), which is located on the forward part of the left rear wheel housing.. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0170603Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the body wire harness connector (2) from the FPCM.
  4. Remove the fasteners (1) that secure the FPCM to the wheel housing.
  5. Remove the FPCM from the vehicle.
scientia non olet · About Mike's Workshop Manuals