Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2021 >> Sprinter 2500 Van Cargo Extended, 2.1L Eng >> Repair and Diagnosis >> External Pages >> Different car >> Section 3190 (Electronic Control Modules (Service Information)) >> Module, Adaptive Cruise Control (Acc) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The molded plastic ball socket clips in the Adaptive Cruise Control (ACC) module mounting bracket are NOT replaceable and should not be removed. Any time the module is replaced the bracket and ball socket clips will be part of the assembly.

  1. Position the ACC module with bracket to the vehicle for installation.
    GC0177974Courtesy of CHRYSLER GROUP, LLC
  2. Connect the wire harness connector (2) to the ACC module.
  3. Install and tighten the fasteners (1) that secure the mounting bracket to the support bar. Tighten the fasteners securely.
  4. Remove the support and lower the vehicle.
  5. Install the front fascia lower closeout panel. Refer to BELLY PAN, FRONT, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  7. Using the scan tool, perform the ACC alignment procedure.
scientia non olet · About Mike's Workshop Manuals