Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2019 >> Sprinter 2500 Van Cargo Extended, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3085 (Electronic Control Modules (Service Information)) >> Module, Adaptive Cruise Control (ACCM) >> Removal And Installation >> Acc Module Bracket >> Removal

Acc Module Bracket: Removal

WARNING: This page is about a different car, the 2018 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
    GC0165311Courtesy of CHRYSLER GROUP, LLC
  3. Using a drill, remove the rivets (1a) holding the bracket (1b) to bumper reinforcement (1c).
  4. Remove the bracket (1b).
scientia non olet · About Mike's Workshop Manuals