Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2018 >> Sprinter 2500 Van Cargo Extended, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3189 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
GC0170603Courtesy of CHRYSLER GROUP, LLC
  1. Position the Fuel Pump Control Module (FPCM) to the forward part of the left rear wheel housing.
  2. Install and tighten the fasteners (1) that secure the FPCM to the left rear wheel housing.
  3. Connect the body wire harness connector (2) to the FPCM connector receptacle.
  4. Install the trim onto the left rear quarter panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals