Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2017 >> Sprinter 3500 Van Cargo Extended, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3189 (Electronic Control Modules (Service Information)) >> Module, Security Gateway (SGW) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If a NEW  Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

  1. Position the SGW module.
  2. Connect the SGW module wire harness connectors.
  3. Install the SGW module retaining bolts and tighten securely.
  4. Install the ICS. Refer to CONTROLS, REAR CABIN COMFORT (RCCC)., REMOVAL AND INSTALLATION MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. If a NEW  SGW module is installed, use the diagnostic scan tool to flash the SGW module.
scientia non olet · About Mike's Workshop Manuals