Recall Campaign 2016070001 - Perform SCN Coding In Garage Door Opener Control Module (2016070001)

Publication date: 2016-07-15
Reference number: 2016070001

RECALL CAMPAIGN 2016070001 - PERFORM SCN CODING IN GARAGE DOOR OPENER CONTROL MODULE

SERVICE CAMPAIGN BULLETIN

Reference Number(s): 2016070001, Date of Issue: July 2016

MERCEDES-BENZ:

Model 213, Model Year 2017

SUBJECT

Model 213, Model Year 2017

Perform SCN Coding in Garage Door Opener Control Module

Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that on certain E-Class vehicles (213 platform), the coding in the overhead control module for the garage door opener does not correspond to current production and may lose the programming. An authorized Mercedes-Benz dealer will update the software.

Prior to performing this Service Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Approximately 4,498 vehicles are affected.

PROCEDURE

NOTE:

Use DAS/Xentry 05-06/16 with add-on 5987 or higher.
Follow the steps exactly as described in DAS/Xentry.
Connect battery charger (battery voltage >12.5V).
Ensure all electrical consumers are switched-off.
In the event of software/SCN update issues, contact Star Diagnosis User Help Desk. Please refer to the "pre-call" check list before contacting UHD
Refer to Star Diagnosis System (SDS) Best Practices Guide.

Perform SCN coding in garage door opener control module:
Quick test view -> N70 overhead control panel (OCP [DBE]) control unit -> LIN: A67n2-garage door opener (GTO) -> Adaptations -> Initial startup.
Follow on-screen instructions.
NOTE: The following allowable labor operation should be used when submitting a warranty claim for this repair:

WARRANTY INFORMATION

Operation:

Connect/disconnect battery charger (02-5058)
Star Diagnosis System (SDS), Connect/disconnect (02-4762)
Perform coding in garage door opener control module (02-9446)

WARRANTY INFORMATION

Damage Code	Operation Number	Labor Time (hrs.)
54 903 39 8	02-5058	0.1
	02-4762	0.1
	02-9446	0.1

NOTE: Operation Number labor times are subject to change.