Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercedes Benz >> 2007 >> CLS63 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems - CLS Class (219) >> TPMS Reset Procedures >> Tire Pressure Monitor System Reactivation

Tire Pressure Monitor System Reactivation

CAUTION: The warning system can only operate in a reliable manner if correct tire pressures are set. If an incorrect tire inflation pressure is set, the system will monitor the pressure according to the incorrect value.
NOTE: Whenever tire pressure has been adjusted, or when wheels or tires have been replaced, the TPM system must be reactivated before it can work.
  1. Ensure inflation pressure of all 4 tires is set to specification.
  2. Switch ignition on. The standard display menu will appear in multifunction display on instrument cluster (shows information such as outside temperature and trip odometer).
  3. Use the scroll forward/back button to select the tire pressure monitoring system.
  4. Press instrument illumination rheostat and reset button. The display will change to the selection screen with "No" preselected.
  5. Press the "+" button (Yes) on the multifunction steering wheel. The selection screen with selection "Yes" appears for approximately 2 seconds and then changes immediately to the confirmation screen. Once the engine has been started the system message "Tire Pressure Displayed Only After Driving a Few Minutes" appears immediately.
    NOTE: Selecting any other button causes the activation sequence to be aborted.
    NOTE: If activation is carried out when the engine is running, this message appears with a time delay of about 30 seconds.
  6. After about 10 minutes of driving time the current tire pressures are displayed. The activation process is complete.
scientia non olet · About Mike's Workshop Manuals