Maintenance Procedure in Maintenance Mode

No	Operation contents
1	Within 60 s	Switch the ignition ON (Ready off) under the following conditions. Shift position: P position Brake pedal: Not depressed
2		Depress the accelerator pedal for the number of times corresponding to the desired mode to be switched to while depressing the brake pedal. (See MAINTENANCE MODE LIST )
3		Release the brake pedal and depress the accelerator pedal again the same number of times.
4		Depress the accelerator pedal the same number of times again while depressing the brake pedal again.
5		Release the brake pedal.
6	When the output limit warning light flashes and is turned off repeatedly for the number of times corresponding to the desired mode to be switched to, the preparation for switching to maintenance mode is completed. (See MAINTENANCE MODE LIST ) If the output limit warning light does not flash because the transition to maintenance mode has failed, switch the ignition OFF and verify if the implementation permit conditions are met. If there is no problem, repeat the procedure from Step 1. NOTE: When the preparation for switching to maintenance mode is completed, maintenance mode is not completed even if the ignition is switched OFF. The mode returns to the transition preparation completion status by switching the ignition ON again after switching the ignition OFF.
7	Depress the brake pedal again and switch the main power ON to switch to the desired mode.
8	Work in maintenance mode.
9	Switch the ignition OFF.