Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Control System (VIN Y)) >> Current Sensor Removal/Installation (VIN Y) >> Current Sensor Installation

Current Sensor Installation

WARNING: This page is about a different car, the 2024 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Connect the negative battery cable before connecting the current sensor connector. If the current sensor connector is connected first, the PCM may mistakenly recognize a signal from the current sensor and learn the battery condition incorrectly.
  • Verifying the tightness while holding the current sensor may apply excessive force to the terminal and the terminal could loosen, causing poor engine starting. When verifying the tightness of the negative battery cable, only hold the terminal area, not the current sensor.
  1. Temporarily install the negative battery cable and the current sensor.
    G16372922Courtesy of MAZDA MOTORS CORP.
  2. Tighten the current sensor nut to the specified torque while fixing the negative battery terminal using a wrench.
Fig 1: Current Sensor Nut With Torque Specification
G16372923Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals