Front ABS Wheel-Speed Sensor Wiring Harness And Clip Disconnection Note
WARNING: This page is about a different car, the 2025 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Refer to this note only if the disconnection of the front ABS wheel-speed sensor wiring harness and the clip shown in the figure is required.
 Courtesy of MAZDA MOTORS CORP.
|
- Insert a flathead screwdriver from the side where there is no notch as shown in the figure below.
 Courtesy of MAZDA MOTORS CORP.
|
- Detach the tab as shown in the figure above and disconnect the ABS wheel-speed sensor wiring harness and clip.