Function inspection: Notes
NOTE:
- Perform the procedure with the M-MDS connected to the DLC-2.
- Switch the main power ON (READY off).
- Display PIDs [ECT_VOLT] and [ECT]. (Refer to PID/DATA MONITOR INSPECTION in the appropriate troubleshooting information )
- Compare the voltage and temperature indications for PIDs [ECT_VOLT] and [ECT] with the standard in the table indicated below.
- If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION [H3T] ).
- If they match the standard, perform the resistance inspection. (See RESISTANCE INSPECTION )