Diagnostic Procedure

WARNING: This page is about a different car, the 2024 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

DTC U3003:17 (FRONT BODY CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN Clear the DTC for the front body control module (FBCM) using the M-MDS. (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)] .) Switch the ignition ON (engine off or on) and wait for 10s or more. Retrieve the front body control module (FBCM) DTCs using the M-MDS. (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)] .) Is the same DTC displayed?	Yes	Go to the next step.
1		No	Go to Step 6.
2	VERIFY PCM DTCs Retrieve the PCM DTCs using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN Y)] .) (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN L (WITHOUT CYLINDER DEACTIVATION))] .) (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN M (WITH CYLINDER DEACTIVATION))] .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (VIN Y)] .) (See DTC TABLE [PCM (VIN L (WITHOUT CYLINDER DEACTIVATION))] .) (See DTC TABLE [PCM (VIN M (WITH CYLINDER DEACTIVATION))] .)
2		No	Go to the next step.
3	INSPECT BATTERY Inspect the battery. (See BATTERY INSPECTION .) Is the battery normal?	Yes	Go to the next step.
3		No	Replace the battery, then go to Step 5. (See BATTERY REMOVAL/INSTALLATION [VIN Y] .) (See BATTERY REMOVAL/INSTALLATION [VIN L (WITHOUT CYLINDER DEACTIVATION)] .) (See BATTERY REMOVAL/INSTALLATION [VIN M (WITH CYLINDER DEACTIVATION)] .)
4	INSPECT GENERATOR Inspect the generator. (See GENERATOR INSPECTION [VIN Y] .) (See GENERATOR INSPECTION [VIN L (WITHOUT CYLINDER DEACTIVATION)] .) (See GENERATOR INSPECTION [VIN M (WITH CYLINDER DEACTIVATION)] .) Is the generator normal?	Yes	Go to the next step.
4		No	Replace the generator, then go to the next step. (See GENERATOR REMOVAL/INSTALLATION [VIN Y] .) (See GENERATOR REMOVAL/INSTALLATION [VIN L (WITHOUT CYLINDER DEACTIVATION)] .) (See GENERATOR REMOVAL/INSTALLATION [VIN M (WITH CYLINDER DEACTIVATION)] .)
5	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the front body control module (FBCM) using the M-MDS. (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)] .) Switch the ignition ON (engine off or on) and wait for 10s or more. Retrieve the front body control module (FBCM) DTCs using the M-MDS. (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)] .) Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the front body control module (FBCM). (See FRONT BODY CONTROL MODULE (FBCM) REMOVAL/INSTALLATION .) Go to the next step.
5		No	Go to the next step.
6	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)] .)
6		No	DTC troubleshooting completed.