Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2024 >> 3 S >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Control System - Auto A/C >> Refrigerant Pressure Sensor Removal/Installation >> Refrigerant Pressure Sensor No. 2 >> Notes

Refrigerant Pressure Sensor No. 2: Notes

NOTE:
  • The refrigerant pressure sensor No. 2 is located in the cooler hose (HI).
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Discharge the refrigerant. (See REFRIGERANT RECOVERY .) (See REFRIGERANT CHARGING .)
  3. Remove the plug hole plate (See PLUG HOLE PLATE REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION)] .) (See PLUG HOLE PLATE REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .)
  4. Remove the cooler hose (HI). (See REFRIGERANT LINE REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) (See REFRIGERANT LINE REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .)
  5. Loosen the refrigerant pressure sensor using two spanners.
    Fig 1: Refrigerant Pressure Sensor With Torque Specifications
    G15641190Courtesy of MAZDA MOTORS CORP.
  6. Remove the refrigerant pressure sensor.
    G14582381Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.
  7. Install in the reverse order of removal. (See REFRIGERANT PRESSURE SENSOR INSTALLATION NOTE .)
  8. Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST .)
scientia non olet · About Mike's Workshop Manuals