DTC C0062-76: SAS Control Module (Poor Installation)
C0062-76: (DSC) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
SAS control module (poor installation) |
| Detection condition |
NOTE:
- The low-G sensor is built into the SAS control module.
- While driving, the electronically controlled brake unit/DSC HU/CM detects that the longitudinal-G value does not change as a result of comparing it to the longitudinal-G calculated from the wheel speed.
|
| Fail-safe |
(See DTC TABLE [DSC]
.) |
| Possible cause |
- SAS control module incorrect installation (Refer to SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA/ISRAEL SPEC.]
in service information.)
- DTCs are stored in the SAS control module. (Low-G sensor malfunction) (See DTC TABLE [SAS]
.)
- Electronically controlled brake unit/DSC HU/CM malfunction (Refer to [ELECTRONICALLY CONTROLLED BRAKE UNIT REMOVAL/INSTALLATION]
in service information.) (Refer to DSC HU/CM REMOVAL/INSTALLATION
in service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See
CLEARING DTC
.)
- Start the electric motor and drive the vehicle at 20 km/h {12 mph} or more.
- Gradually slow down and stop vehicle.
|
| System wiring diagram |
|