Servicing procedure
- Removal/installation and disassembly/assembly procedures are shown using figures so that the component part names, installed or assembled condition, and component units are understandable. However, removal/installation procedures which have few steps have only written instructions.
- In the structural view, the servicing procedure is indicated by numbers, and the grease application position, special service tool (SST) location of use, non-reusable parts, and tightening torque are specified.
- Procedure steps are numbered and the part that is the main point of that procedure is shown in the illustration below with the corresponding number. For procedures which have important points in particular, such points are explained in detail as notes. Always refer to the notes.