Blind Spot Monitoring (BSM) Control Module Inspection: Notes
NOTE:
- There are 2 types of blind spot monitoring (BSM) control modules. For the verification method, refer to [BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION]. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .)
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
- Rear splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION .)
- Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION .)
- Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).
- If the system does not operate normally even though the inspection items are normal, replace the BSM control module.
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).