Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2022 >> MX-5 Miata Club >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Control (5 Of 6) >> DTC P1200-00: Low Fuel Injection Amount >> Function Inspection Using M-MDS

Function Inspection Using M-MDS

DIANOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step Inspection Results Action
1 PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 PURPOSE: RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION 
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
3 PURPOSE: INSPECT FOR OTHER RELATED DTCs 
  • Switch the ignition off, then ON (engine off).
  • Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST [PCM ] .)
  • Is the PENDING CODE/DTC P0171:00 also present?
 Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC P0171-00: .)
Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
No Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
scientia non olet · About Mike's Workshop Manuals