Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2022 >> CX-5 S Select >> Repair and Diagnosis >> External Pages >> Different car >> Section 280 (Control System - Auto A/C) >> Passenger Compartment Temperature Sensor Removal/Installation (Auto A/C)

Passenger Compartment Temperature Sensor Removal/Installation (Auto A/C)

WARNING: This page is about a different car, the 2021 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Driver-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
    4. Hood release lever (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION .)
    5. Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION .)
    6. Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
    G11431894Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the aspirator from the passenger compartment temperature sensor.
  5. Remove the screw.
    G11431895Courtesy of MAZDA MOTORS CORP.
  6. Remove the passenger compartment temperature sensor.
    G11431896Courtesy of MAZDA MOTORS CORP.
  7. Remove the aspirator.
    G11431897Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals