Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2022 >> 3 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Dynamic Stability Control (Service Information)) >> Front Abs Wheel-Speed Sensor Removal/Installation >> Front ABS Wheel-speed Sensor Wiring Harness and Clip Disconnection Note

Front ABS Wheel-speed Sensor Wiring Harness and Clip Disconnection Note

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Refer to this note only if the disconnection of the front ABS wheel-speed sensor wiring harness and the clip shown in the figure is required.
  1. Remove the front ABS wheel-speed sensor wiring harness and clip as shown in the figure.
    G13558409Courtesy of MAZDA MOTORS CORP.
  2. Remove the front ABS wheel-speed sensor wiring harness and clip as shown in the figure.
G13176292Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals