Diagnostic Procedure
DTC U0515:68 (BLIND SPOT MONITORING CONTROL MODULE) DIAGNOSTIC PROCEDURE
| STEP | Inspection | ACTION | |
|---|---|---|---|
| 1 | VERIFY START STOP UNIT DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .) |
| No | Go to the next step. | ||
| 2 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | Go to the next step. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the blind spot monitoring (BSM) control module (LH), then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||