Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2021 >> CX-9 Signature >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Control System (4 Of 6) >> DTC P0500-00: VSS Circuit Problem >> Diagnostic Procedure

Diagnostic Procedure

DTC P0500:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
- Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY STORED DTC IN DSC HU/CM
Yes Go to the applicable DTC inspection.
(See DTC TABLE [DSC HU/CM] .)
No Go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Always reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the MMDS. (See CLEARING DTC [PCM (SKYACTIV-G 2.5T)] .)
  • Access the RPM and LOAD PIDs using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)] .)
    CAUTION:
    • While performing this step, always operate the vehicle in a safe and lawful manner.
    • When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later.
  • Drive the vehicle under the following conditions for 14 s.
    • Shift position: except P or N position
    • Absolute load: above 40 %
    • Engine speed: above 2, 000 rpm
      • Brake switch: OFF
  • Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)] .)
  • Is the PENDING CODE for this DTC present?
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE
Yes Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-G 2.5T)] .)
No DTC troubleshooting completed.