Diagnostic Procedure
DTC U3000:54 [BLIND SPOT MONITORING (BSM) CONTROL MODULE] DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | INSPECT REAR BUMPER SURFACE
|
Yes | Go to the next step. |
| No | Remove dirt or foreign material (reflective object), then go to Step 5. | ||
| 2 | INSPECT AREA AROUND BLIND SPOT MONITORING (BSM) CONTROL MODULE
|
Yes | Go to the next step. |
| No | Remove dirt or foreign material (reflective object), then go to Step 5. | ||
| 3 | VERIFY CONTROL MODULE INSTALLATION CONDITION
|
Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part, then go to Step 5. | ||
| 4 | PERFORM BLIND SPOT MONITORING (BSM) RADAR TEST
|
Yes | Go to the next step. |
| No | Go to Step 6. | ||
| 5 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 6 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||