Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2021 >> CX-30 Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Control System (VIN L)) >> Engine Coolant Temperature (ECT) Sensor Removal/Installation >> ECT sensor No. 2 >> Notes

ECT sensor No. 2: Notes

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
  3. Remove the coolant control valve. (See COOLANT CONTROL VALVE REMOVAL/INSTALLATION .)
  4. Remove the short cord.
    G13175436Courtesy of MAZDA MOTORS CORP.
  5. Remove the ECT sensor No. 2 using the SST.
    Fig 1: ECT Sensor No. 2 With Torque Specification
    G13175437Courtesy of MAZDA MOTORS CORP.
  6. Install in the reverse order of removal.
  7. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
scientia non olet · About Mike's Workshop Manuals