Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2021 >> CX-3 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Charging System) >> Battery Removal/Installation >> Battery Tray and PCM Component Removal Note

Battery Tray and PCM Component Removal Note

WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner, air hose and fresh air duct component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  2. Remove the nut securing the wiring harness protector to the battery tray.
    Fig 1: Identifying Wiring Harness Protector Nuts With Torque Specifications
    G10900819Courtesy of MAZDA MOTORS CORP.
  3. Release the wiring harness clips in the two locations shown in the figure.
    Fig 2: Locating Wiring Harness Clip
    G10968991Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the PCM connector shown in the figure.
    Fig 3: Identifying PCM Connector
    G10968992Courtesy of MAZDA MOTORS CORP.
  5. Remove the battery tray and PCM component as a single unit.
scientia non olet · About Mike's Workshop Manuals