Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2020 >> CX-5 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Entertainment System) >> Bluetooth® PAIRING PROCEDURE >> Introduction >> If Bluetooth®-enabled device is version 2.0

If Bluetooth®-enabled device is version 2.0

WARNING: This page is about a different car, the 2020 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch the ignition ON (engine off or on).
  2. Select "Settings" from the home screen of the center display as shown in the figure.
    G09784168Courtesy of MAZDA MOTORS CORP.
  3. Select the following on the center display.
    1. [Devices]
    2. [Bluetooth]
    3. Bluetooth setting ON
    4. [Add New Device]
  4. Verify that the 4-digit pairing code (initial value "0000") is indicated in the center display.
  5. Input the 4-digit pairing code indicated in the center display into the Bluetooth®-enabled device.
    NOTE:
    • After inputting the 4-digit pairing code, the CMU initiates the pairing programming with the Bluetooth®-enabled device.
  6. Verify that "Pairing complete Connection complete" is indicated in the center display.
scientia non olet · About Mike's Workshop Manuals