Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2020 >> CX-30 Select, AWD >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Control System (1 Of 4) >> DTC P0087-00: Fuel Pressure Sensor Circuit Range/Performance Problem >> Details On DTCs

Details On DTCs

DTC P0087:00 (PCM, SKYACTIV-G) DETECTION CONDITION AND POSSIBLE CAUSE

Description Fuel pressure sensor circuit range/performance problem
Detection condition Determination conditions
  • If any of the following conditions is met under condition A or condition B:

    Condition A:

    • The actual fuel pressure is lower than the target fuel pressure by 1.2 MPa {12 kgf/cm2 , 174 psi} or more even though the fuel pressure feedback amount is maintained high.

    Condition B:

    • The PCM detects that the actual fuel pressure is 1.7 MPa {17 kgf/cm2 , 247 psi} or less continuously or intermittently.
Preconditions
  • Engine speed: 500 rpm or more*1
  • The following DTCs are not detected:
    • Fuel pressure sensor: P0089:00, P0192:00 and P0193:00
      • High pressure fuel pump: P0091:00 and P0092:00
*1 : Standard can be verified by displaying PIDs using M-MDS
Malfunction determination period Condition A:
  • 5 s period

Condition B:
  • Specified time
Drive cycle
  • 1
Self test type
  • CMDTC self test
Sensor used
  • Fuel pressure sensor
Fail-safe function
  • Limits intake air amount
  • Stops high pressure fuel pump control
Vehicle status when DTCs are output
  • Not applicable
Possible cause
  • Air suction in fuel line due to fuel is runout
  • High pressure fuel pump connector or terminals malfunction
  • Fuel pressure sensor connector or terminals malfunction
  • PCM connector or terminals malfunction
  • Fuel pressure sensor malfunction
  • Fuel delivery system malfunction (insufficient fuel pressure)
  • Fuel injector malfunction
  • High pressure fuel pump malfunction
    • Relief valve (built-into high pressure fuel pump) malfunction