Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2020 >> 6 Signature >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Basic System - HVAC >> Blower Fan Controller Removal/Installation

Blower Fan Controller Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
    2. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
    3. Passenger-side front heat duct (See FRONT HEAT DUCT REMOVAL/INSTALLATION .)
  3. Disconnect the blower fan controller connector.
    Fig 1: Disconnecting Blower Fan Controller Connector
    G12233457Courtesy of MAZDA MOTORS CORP.
  4. Rotate the blower fan controller (2) while pressing the tab (1).
    Fig 2: Rotating Blower Fan Controller
    G12233458Courtesy of MAZDA MOTORS CORP.
  5. Remove the blower fan controller.
    Fig 3: Blower Fan Controller
    G12233459Courtesy of MAZDA MOTORS CORP.
  6. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals