Engine Oil Level Inspection

WARNING: This page is about a different variant/trim than selected.

Position the vehicle on level ground.
Warm up the engine.
Stop the engine and allow at least 5 min before continuing.
Remove the dipstick, wipe it cleanly, and reinstall it fully.
Remove the dipstick and verify that the oil level is between the MAX and MIN marks on the dipstick.

Fig 1: MAX And MIN Marks On Dipstick
Courtesy of MAZDA MOTORS CORP.
- If the oil level is below or near the MIN mark, add engine oil. (See ENGINE OIL REPLACEMENT [SKYACTIV-G 2.5 (VIN M)] .)
- If the oil level is above the MAX mark, penetration of fuel into the engine oil can be considered. Replace the engine oil. (See ENGINE OIL REPLACEMENT [SKYACTIV-G 2.5 (VIN M)] .)
Insert the dipstick completely until it attaches to the cylinder head cover.