Function Inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID IAT2. (See ON-BOARD DIAGNOSTIC TEST (VIN Y) .) (See PCM INSPECTION (VIN Y) .)
- Compare the voltage and temperature indications for the PID IAT2 with the standard in the table indicated below.
- If they do not match the standard, perform the resistance inspection. (See RESISTANCE INSPECTION .)
Standard
IAT2 VOLTAGE SPECIFICATION
| IAT2 | |
|---|---|
| V | °C {°F} |
| Approx. 3.57 | 20 {68} |
| Approx. 2.70 | 40 {104} |
| Approx. 1.87 | 60 {140} |