Diagnostic Procedure

DTC C101F:98 (DSC HU/CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY DSC HU/Control Module DTC Using the M-MDS, clear the DTC from the DSC HU/Control Module. (See CLEARING DTC (DSC HU/CONTROL MODULE) .) Using the M-MDS, perform the DSC HU/Control Module DTC inspection. (See DTC INSPECTION (DSC HU/CONTROL MODULE) .) Is the same DTC present?	Yes	Replace the DSC HU/Control Module, then go to the next step. (See DSC HU/Control Module REMOVAL/INSTALLATION .)
1		No	Go to the next step.
2	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE (DSC HU/CONTROL MODULE) .)
2	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.