Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
DTC U0415:68 (ELECTRONIC AWD CONTROL SYSTEM) DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | INSPECT FOR DSC HU/Control Module MALFUNCTION
|
Yes | Go to applicable DTC inspection. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)] .) |
| No | Go to the next step. | ||
| 2 | VERIFY THAT THE SAME DTC IS NOT PRESENT
|
Yes | Repeat the inspection from Step1. If the malfunction recurs, replace the DSC HU/Control Module, then go to the next step. (See DSC HU/Control Module REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .) |
| No | Go to the next step. | ||
| 3 | VERIFY THAT NO OTHER DTCS ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See ELECTRONIC AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS (Electronic AWD Control System) .) |
| No | DTC troubleshooting completed. | ||